View of the mount

The range of mobility

The PD102 E9655 mount has been designed for mounting on the ceiling a multimedia projector. Its load capacity is 15 kg. The mount allows 360 deg rotation, and due to telescopic construction of the arm - easy (without additional tools) adjustment of vertical position of the projector.

The ceiling has to carry the load of the projector and the mount, including a wide margin of safety.

The mount cannot be installed on ceilings that do not provide firm hold (steel stud, old cinder block, suspended ceilings etc). If you are uncertain about the nature of your ceiling, consult an installation company.
The set contains all components needed for typical installation. In some specific conditions there may be required auxiliary elements or tools that should be supplied by professionals installing this type of hardware.
The basic required tools (not included): 3/16" drill bit, 1/2" masonry bit for concrete block installations, electric drill, wrench or socket set, Phillips screwdriver.

Safety warning.

The set includes assembly instructions. If you do not understand those directions, or have any doubts about the safety of the installation, please call a qualified installer. Improper installation may cause damage or serious injury.
Before mounting check carefully to make sure there are no missing or defective parts. If you have any doubts do not begin installation.

Some operations should be performed by two skilled people!

Improper installation may cause damage or serious injury.
Do not use this product for any other purpose than specified.
Neither the producer nor distributor shall be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use.

Name	Projector ceiling mount PD102
Code	E9655
Distance from ceiling (adjustable)	235 - 310 mm
FDMI / MIS	VESA
Load capacity	15 kg
Tilt adjustment	30°
Rotation range	360°
Dimensions	185x(235-310)x182 mm
Weight	1.75 kg