View of the mount

The mobility range

The DL102 E9643 arm has been designed to place modern LCD monitor/television on a wall. Its maximum capacity is 15 kg, so it is suitable for light models. The mount allows easy adjustment of tilt (without additional tools) in the range of 10 degrees. It also provides up to 180 degrees swivel for optimal screen positioning.

The wall has to carry the load of the panel and the mount, including a wide margin of safety.

The mount cannot be installed on walls that do not provide firm hold (steel stud, old cinder block, plaster panel etc). If you are uncertain about the nature of the wall, consult an installation company.
The set contains all components needed for typical installation. In some specific conditions there may be required auxiliary elements or tools that should be supplied by professionals installing this type of hardware.
The basic required tools (not included): 3/16" drill bit, 1/2" masonry bit for brick / concrete block installations, electric drill, wrench or socket set, Phillips screwdriver.

Safety warning.

The set includes assembly instructions. If you do not understand those directions, or have any doubts about the safety of the installation, please call a qualified installer. Improper installation may cause damage or serious injury.
Before mounting check carefully to make sure there are no missing or defective parts. If you have any doubts do not begin installation.

Some operations should be performed by two skilled people!

Improper installation may cause damage or serious injury.
Do not use this product for any other purpose than specified.
Neither the producer nor distributor shall be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use.

Name	LCD wall arm DL102 - tilt, swivel
Code	E9643
Screen size range	13” – 30”
Distance from wall	70 - 245 mm
FDMI / MIS	VESA 75,100
Load capacity	15 kg
Tilt adjustment	10°
Rotation angle	180°
Dimensions	245x195x(70-240) mm
Weight	1 kg