Top-quality F-connector Platinum for use on TRISET-11 coax.

The connector has been designed to ensure watertightness (after crimping) both from the side of the cable and the device. Inside the threaded bush (from the side of the device) there is special gasket. During compression of the connector another plastic bush is tightly pressed against the sheath of the cable (by putting on cone brass case - the compression ring). The plastic material is protected by patent Delrin of well known for quality of products DuPont company. It is UV-proof, and ensures stable physical parameters in very wide temperature range.
The metal parts of the connector made of nickel-plated brass are corrosion-proof.

The way of crimping ensures high mechanical strength, watertightness, and stability of parameters. The compression should be made with the crimping tool E80077.

* Derlin 527UV is high-quality special plastic

Front view

Rear view

Remove cable jacket and dielectric at the length of 5 mm.
Then remove only the jacket (sheath) at the length of 4 mm.

View of the cable prepared for termination

Put the central pin (in the set) on the central wire and the whole end insert into the main part of the connector.

TRISET-11 with the connector on (before compression)

TRISET-11 with the connector crimped on

Notice: Before crimping the connector onto the cable the adapter of the crimping tool has to be set for TRISET-11.

The connector in the crimping tool - crimp until compression ring is fully seated in connector body

The termination of the cable is ready!