| No. | Name | Code |
1 |
|
|
|
|
| Specific conditions and requirements, concept, design, future development, cabling. ... more »
|
|
|
| konspekt01 |
2 |
|
|
|
|
| Most of parameters can be measured using selective signal level meters. Performing such measurements is not a waste of time but essential stage for proper design, and, the next - even more important - of verification of the work done. The measurements allow to verify correctness of the design and its implementation, as well as quickly find the errors arising both at concept and realization stages.... more »
|
|
|
| bib09 |
3 |
|
|
|
|
| A common problem that is encountered in terrestrial TV antenna installations is unbalance of the level of received channels, often about 10-20 dB. In case of small installations (5-20 outlets) such a difference (not recommended) usually doesn't make any trouble yet. It is the real problem for bigger installations, where the difference of levels at the input is increased by inconstant (being a function of frequency) attenuation of cables and may easily exceed (in an outlet) the accepted limit (12 dB) all over the band.... more »
|
|
|
| bib69 |
4 |
|
|
|
|
| Community antenna (MATV system) may be defined as antenna installation where compensation of network attenuation is performed by one central set of amplifiers. The amplifiers can be connected in a cascade.... more »
|
|
|
| bib05 |
5 |
|
|
|
|
| QAM modulation is optimal for cable networks. It is used in cable band/hyper-band (S channels) and UHF band. Due to the need of compatibility with channel raster and transmission requirements, there are used 8 MHz channels (MPEG-2 compression, QAM modulation).... more »
|
|
|
| bib41 |
6 |
|
|
|
|
| One of the important parameters of amplifiers is their maximum output level. It is the level which can appear in the amplifier output without exceeding an acceptable level of nonlinear or crossover distortions.... more »
|
|
|
| bib64 |
7 |
|
|
|
|
| Thanks to digital technology, satellite industry has increased the number of channels that are broadcast from one transponder - there may be transmitted 5, 8, or even more TV programs.
It lowers operating costs and makes possible to multiply the offer from a single satellite. The important factor is compression level that can be changed according to the intended quality of the image.... more »
|
|
|
| bib01 |
8 |
|
|
|
|
| RF cable network should fulfill regulations of electromagnetic shielding. It cannot radiate energy that exceeds determined level and it should be resistant enough to outer electromagnetic radiation.... more »
|
|
|
| bib53 |
9 |
|
|
|
|
| MPEG-4 is the newest video compression standard which quickly becomes popular, also in the case of video streaming. In comparison with previously presented standards, it integrates effective methods for multimedia data.... more »
|
|
|
| bib76 |
10 |
|
|
|
|
| To ensure proper S/N ratio, the isolation between any two receivers should be at least 50 dB.When the receivers are connected to the same tap, the isolation depends on the Ao, A, and As attenuation, and the lengths of the cable between tap outputs and subscriber outlets.... more »
|
|
|
| bib65 |
11 |
|
|
|
|
| Separation between outputs of splitters (crosstalk attenuation) is very important parameter of the devices. It determines level of interferences coming from other branches of the network connected to the splitter. It should be as high as possible.... more »
|
|
|
| bib43 |
12 |
|
|
|
|
| An ideal band-stop filter has no attenuation in the pass-band, 90-degree steep slope, and infinitely high attenuation in rejection band.... more »
|
|
|
| bib17 |
13 |
|
|
|
|
| Locations and parameters of terrestrial analog and digital TV transmitters in Poland (information suitable for Polish-speaking users only)... more »
|
|
|
| bib07 |
14 |
|
|
|
|
| TV channels used in Poland and some other European countries for terrestrial and cable TV broadcasting. In Poland there is used PAL DK standard, with continuous numbering (e.g. after S8 we have S9). We have also presented PAL BG channels used mostly in Western European countries.
... more »
|
|
|
| bib02 |
15 |
|
|
|
|
| In the table there is comparison of signal level and corresponding voltage. ... more »
|
|
|
| bib04 |
16 |
|
|
|
|
| Symbols used in block and wiring diagrams of community antenna installations in Poland (information suitable for Polish users only)... more »
|
|
|
| bib14 |
