Support
Details
Etrix 1VADA-R is used to receive video, audio, and data from one CCTV camera via 8-wire CAT5e UTP cable over distances up to 2400 m (using active transmitter and preserving original quality).
The device matches the 100 ohm impedance of the balanced transmission lines to the 75 ohm impedance of unbalanced inputs of a DVR etc. Used in video surveillance systems, such devices allow efficient design of transmission lines without hard wiring.
The device matches the 100 ohm impedance of the balanced transmission lines to the 75 ohm impedance of unbalanced inputs of a DVR etc. Used in video surveillance systems, such devices allow efficient design of transmission lines without hard wiring.
LED indicators
- red: POWER
- green: VIDEO
Distinguishing features
- reception of one video signal
- reception of one audio signal
- two data channels
- cooperation with passive transmitters (the maximum transmission distance is 1500 m)
- cooperation with active transmitter (the maximum transmission distance is 2400 m)
- built-in anti-interference filters
The type of cable and connector wiring
A UTP cable rated CAT5 or higher is required. The quality of the cable used has a direct impact on the image quality and transmission range.
The wires should be connected (using a crimping tool, e.g. J9210) in accordance with the scheme TIA/EIA-586B for RJ-45 connectors. Coaxial cables terminated with BNC plugs are to be connected to the BNC sockets.

RJ-45 wiring
Settings
"Sharpness" DIP switch allows to adjust the receiver to the parameters of transmission line in order to get the best results. A suitable brightness level of the received video can be set with "Brightness" knob.
Application diagram

The combination of active transmitter and receiver
allowing transmission of video, audio, and data
allowing transmission of video, audio, and data
Specifications:
Name | Etrix 1VADA-R |
Code | M16743 |
Frequency range | 0...8 MHz |
CMRR | 60 dB |
Impedance of coaxial outputs | 75 ohm |
Impedance of balanced inputs | 100 ohm |
Differential capacity (max) | 62 pF/m |
Supported standards | NTSC, PAL, SECAM, CCIR |
Power | 12 VDC / 160 mA |
Operating temperature | -10...70 °C |
Storage temperature | -30...70 °C |
Dimensions | 105 x 58 x 29 mm (except for BNC sockets) |
Specifications
Nazwa | Etrix 1VADA-R |
Kod | M16743 |
Częstotliwość | 0...8 MHz |
CMRR | 60 dB |
Impedancja BNC | 75 Ohm |
Impedancja RJ-45 | 100 Ohm |
Pojemność dyferencjalna (max) | 62 pF/m |
Obsługiwane standardy | NTSC, PAL, SECAM, CCIR |
Zasilanie | DC12V / 160mA |
Temperatura pracy | -10...70 °C |
Temperatura przechowywania | -30...70 °C |
Wymiary zewnętrzne | 105x 58 x 29mm (wyłączając gniazda BNC) |