View of the mount

Sketch of the mount

The mount DP107L E9623 has been designed to place a modern LCD or plasma monitor / television on a wall. Its load capacity is 100 kg. The wall mount bracket allows easy adjustment of tilt (without additional tools) in the range 15 degrees. It is also possible to rotate the panel (+/- 40 degrees) and adjust the distance from the wall.

The mount cannot be installed on walls that do not provide firm hold (steel stud, old cinder block, plaster panel etc). If you are uncertain about the nature of the wall, consult an installation company.
The set contains all components needed for typical installation. In some specific conditions there may be required auxiliary elements or tools that should be supplied by professionals installing this type of hardware.
The basic required tools (not included): 3/16" drill bit, 1/2" masonry bit for brick / concrete block installations, electric drill, wrench or socket set, Phillips screwdriver.

The set includes assembly instructions. If you do not understand those directions, or have any doubts about the safety of the installation, please call a qualified installer. Improper installation may cause damage or serious injury.
Before mounting check carefully to make sure there are no missing or defective parts. If you have any doubts do not begin installation.

Improper installation may cause damage or serious injury.
Do not use this product for any other purpose than specified.
Neither the producer nor distributor shall be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use.