VGA Extender Signal HD (VGA to IP)
Code: H3618
General view
View of the opposite side (visible AUDIO IN/OUT connectors)
The included power supplies
VGA extender Signal HD allows for connecting a monitor or television with VGA input to a remote (up to 100 m) source of signal with VGA output. The video signal that can have resolution up to 1920x1080@60Hz is converted into IP stream and transmitted via cat. 5e or cat. 6 twisted pair cable. The set includes transmitter, receiver and 2 power supplies.
Key features
- Transmission via a single Cat. 5e/6 cable
- UDP/IP protocol (multicast)
- Transmission of stereo sound
- Possibility of point-to-multipoint topology
- Supported resolutions: 1920x1080@60Hz, 1680x1050@60Hz, 1440x900@60Hz, 1360x768@60Hz, 1280x1024@60Hz, 1280x960@60Hz, 1280x720@60Hz, 1024x768@60Hz, 800x600@60Hz
- Maximum length of transmission cable: 100 meters
IP signal coming from the transmitter may be applied to an Ethernet switch to split it among multiple receivers. The bit rate of the compressed signal at the output of the transmitter operating in multicast mode is about 20 Mbps. The output signal can be properly decoded only by the dedicated receivers - it cannot be done by a PC equipped with a network card.
The set is perfect for connecting remote HD source like PC or DVR/NVR with VGA output to HD-enabled TV/monitor/projector with VGA input. It requires to use only one, comparatively thin cable, which makes it easy to hide it, e.g. when installing the TV/monitor on an LCD mount.
An application of the VGA > IP converter/extender (point-to-point)
Another application of the VGA > IP converter/extender units (point-to-multipoint)
Remark!
It is possible to change the VGA + AUDIO signals to HDMI by the application of the transmitter from the Signal HD VGA extender set and the Signal HD receiver H3615 (IP to HDMI). This way the original signals (VGA + AUDIO) transmitted over UTP cable over a distance up to 100 meters can be played on any monitor/television with HDMI input.
It is possible to change the VGA + AUDIO signals to HDMI by the application of the transmitter from the Signal HD VGA extender set and the Signal HD receiver H3615 (IP to HDMI). This way the original signals (VGA + AUDIO) transmitted over UTP cable over a distance up to 100 meters can be played on any monitor/television with HDMI input.
Specifications
| Name | VGA Extender Signal HD (VGA to IP) |
| Code | H3618 |
| Supported video formats | 1920x1080@60Hz, 1680x1050@60Hz, 1440x900@60Hz, 1360x768@60Hz, 1280x1024@60Hz, 1280x960@60Hz, 1280x720@60Hz, 1024x768@60Hz, 800x600@60Hz |
| Max length of UTP/FTP cable (cat. 5e or higher) | 100 m |
| Operating temperature range | -10ºC...60ºC |
| Audio input/output | mini JACK |
| Operating humidity (RH) | 20%...90% (no condensation) |
| Dimensions | 138x90x24 mm |
| Power | 230 VAC / 5 VDC |
VGA Extender Signal HD (VGA to IP)
Code: H3618