VGA Extender Signal HD (VGA to IP) - Receiver (IP to VGA)
Code: H3619
General view
View of the opposite side (visible AUDIO OUT connector)
The receiver is supplied with one PSU
The Signal HD receiver is normally a part of the H3618 set, but is also sold separately as the H3619 item. This enables any user to make use of the multicast mode and receive the signal transmitted over cat. 5e/6 twisted pair cable on a number of monitors/televisions, each connected via the receiver.
Key features
- Transmission via a single Cat. 5e/6 cable
- UDP/IP protocol (multicast)
- Transmission of stereo sound
- Possibility of point-to-multipoint topology
- Supported resolutions: 1920x1080@60Hz, 1680x1050@60Hz, 1440x900@60Hz, 1360x768@60Hz, 1280x1024@60Hz, 1280x960@60Hz, 1280x720@60Hz, 1024x768@60Hz, 800x600@60Hz
- Maximum length of transmission cable: 100 meters
IP signal coming from the transmitter may be applied to an Ethernet switch to split it among multiple receivers. The bit rate of the compressed signal at the output of the transmitter operating in multicast mode is about 20 Mbps. The output signal can be properly decoded only by the dedicated receivers - it cannot be done by a PC equipped with a network card.
The set is perfect for connecting remote HD source like PC or DVR/NVR with VGA output to HD-enabled TV/monitor/projector with VGA input. It requires to use only one, comparatively thin cable, which makes it easy to hide it, e.g. when installing the TV/monitor on an LCD mount.
An application of the VGA > IP converter/extender (point-to-point)
Another application of the VGA > IP converter/extender units (point-to-multipoint)
Remark!
It is possible to change the VGA + AUDIO signals to HDMI by the application of the transmitter from the Signal HD VGA extender set and the Signal HD receiver H3615 (IP to HDMI). This way the original signals (VGA + AUDIO) transmitted over UTP cable over a distance up to 100 meters can be played on any monitor/television with HDMI input.
It is possible to change the VGA + AUDIO signals to HDMI by the application of the transmitter from the Signal HD VGA extender set and the Signal HD receiver H3615 (IP to HDMI). This way the original signals (VGA + AUDIO) transmitted over UTP cable over a distance up to 100 meters can be played on any monitor/television with HDMI input.
Specifications
| Name | VGA Extender Signal HD - receiver (IP to VGA) |
| Code | H3619 |
| Supported video formats | 1920x1080@60Hz, 1680x1050@60Hz, 1440x900@60Hz, 1360x768@60Hz, 1280x1024@60Hz, 1280x960@60Hz, 1280x720@60Hz, 1024x768@60Hz, 800x600@60Hz |
| Max length of UTP/FTP cable (cat. 5e or higher) | 100 m |
| Operating temperature range | -10ºC...60ºC |
| Audio output | mini JACK |
| Operating humidity (RH) | 20%...90% (no condensation) |
| Dimensions | 138x90x24 mm |
| Power | 230 VAC / 5 VDC |
VGA Extender Signal HD (VGA to IP) - Receiver (IP to VGA)
Code: H3619