English
Polski
Česky
Deutsch
Irish
Magyar
Português
Română
Slovenský
The tap distributes amplified GSM/DSC/UMTS/LTE signals to indoor antennas A741001, A741002. Operating band: 800...2500 MHz; connectors: N-f.
Wireless range extender Mercusys MW300RE is designed to increase the range and signal strength of existing wireless networks to eliminate dead zones.
Two-way GSM splitter for distributing amplified GSM signal between indoor GSM antennas A741001, A741002. The splitter can operate within 800-2500 MHz range. It is equipped with N-female connectors.
• Splitting the amplified GSM signal into two paths
• For connecting two indoor antennas
• There are versions with 3 and 4 ouputs
• For connecting two indoor antennas
• There are versions with 3 and 4 ouputs
Three-way GSM splitter for distributing amplified GSM signal among three indoor GSM antennas A741001. The splitter can operate between 800 and 2500 MHz. It is equipped with N-female connectors.
The xPoE-4-11A-HS has been designed as LAN extender (repeater) and PoE power supply.
• Compact device size
• Powered from another PoE switch in 802.3at, 802.3af or Passive (PoE IN port)
• Possibility to power up to 3 PoE receivers 802. 3 PoE 802. 3at/af or PASSIVE receivers (PoE OUT ports)
• Power can be turned off on selected PoE ports
• Improves and distributes network signal (fully functional 100Mbps switch)
• Up to 40W total power for all ports
• Electronic fuse on PoE IN input Electronic fuse on PoE IN input
• Cascade power supply (one xPoE powers another)
• Easy and fast startup without configuring parameters
• Selectable PoE standard (at/af)
• Sequential start of PoE outputs
• Very low power consumption (<0.5W)
• Powered from another PoE switch in 802.3at, 802.3af or Passive (PoE IN port)
• Possibility to power up to 3 PoE receivers 802. 3 PoE 802. 3at/af or PASSIVE receivers (PoE OUT ports)
• Power can be turned off on selected PoE ports
• Improves and distributes network signal (fully functional 100Mbps switch)
• Up to 40W total power for all ports
• Electronic fuse on PoE IN input Electronic fuse on PoE IN input
• Cascade power supply (one xPoE powers another)
• Easy and fast startup without configuring parameters
• Selectable PoE standard (at/af)
• Sequential start of PoE outputs
• Very low power consumption (<0.5W)
