PW5DK is an exit pushbutton, used in video intercom and access control systems.
• Material: aluminum
• Pushbutton contacts: NO/NC/COM
• Tested for more than 500 thousand clicks
• Bell-type pushbutton
• Installation: flush-mounted
• Pushbutton contacts: NO/NC/COM
• Tested for more than 500 thousand clicks
• Bell-type pushbutton
• Installation: flush-mounted
The active converter kit allows Ethernet data and PoE power to be transmitted over a single pair of cables. Ideal when replacing cabling is not possible or cost-effective.
• Ethernet transmission over any 2 wires of cable
• Transmission of 100 Mbps up to 300 m and 10 Mbps up to 800 m (UTP cable)
• Power supply possible from PoE switch in 802.3af, 802.3at standard or PoE Passive (PoE IN port)
• Clear indication of operation, bandwidth and transmission status
• Small size of the device enabling installation in small spaces, e.g. in a camera base
• Low power consumption of the device (< 1.35 W)
• Easy and quick start-up without configuring parameters
• Wide operating temperature range
• Transmission of 100 Mbps up to 300 m and 10 Mbps up to 800 m (UTP cable)
• Power supply possible from PoE switch in 802.3af, 802.3at standard or PoE Passive (PoE IN port)
• Clear indication of operation, bandwidth and transmission status
• Small size of the device enabling installation in small spaces, e.g. in a camera base
• Low power consumption of the device (< 1.35 W)
• Easy and quick start-up without configuring parameters
• Wide operating temperature range
The relay module is used to control and signal states, such as in alarm and access control systems.
• Relay with C/N/NO contacts for voltage up to 30 V DC or 48 VD AC with maximum current 1 A
• Serial fuse in relay circuit (C, NO, NC)
• Serial fuse in relay circuit (C, NO, NC)
The device reduces the voltage on the DC plug to 12 V and simultaneously transfers PoE power to the RJ45 output.
• PoE voltage reduction from 48 V to 12 V – available at a DC plug (illuminator, microphone, heater)
• Provides PoE power supply from the input to the RJ45 output (camera power supply)
• Can be powered with PoE 802.3af or PASSIVE switch
• Compact module size
• Provides PoE power supply from the input to the RJ45 output (camera power supply)
• Can be powered with PoE 802.3af or PASSIVE switch
• Compact module size



