F-connector F MASTER 11 (compressed on Triset-11)

The monolithic E80362 F-connector is made ​​of brass plated with nickel and is specially prepared for Triset-11 cable. High precision ensures superior quality and professional look. The compression method of installation is very simple and guarantees good and stable connection for a long time. Precise thread of the F MASTER E80362 connector eliminates problems with screwing the connectors on sockets, which can happen with other plugs. Double compression rings of the F MASTER E80362 connector (on the cable and the O-ring seal on the connection side) fully protect the cable and the connection (also the equipment) against water penetration.

The F MASTER 11 E80362 connector is suitable for:

The connectors should be compressed with the E80075 compression tool.

A very good tool for preparing cable ends is the insulation stripper E8010.

• wide operating bandwidth
• watertight connector to cable connection
• very low attenuation over the entire operating band
• excellent adaptation to the transmission line in the whole operating band
• very simple and quick assembly - way of crimping: longitudinal compression
• properly crimped connector is very difficult to tear off the cable - two compression rings
• connector is a monolithic unit
• it is dimensionally matched to the Triset-11 PE cable family
• the construction of this connector is protected by numerous patents
• preparation of the cable for crimping (stripping) should be done with tool E8010
• for crimping, the compression tool E80075 should be used
• when comparing this connector with others, it should be noted that the speed, assembly safety and stability of the connection made correspond to the price of the connector