Configuration of DVB-T receiver, designed for home use, capable of connecting to older tvs
€0.39
Price | Disc. | Quantity | Validity |
---|---|---|---|
€0.39 | 0 % | from 1 piece |
Available
The monolithic nickel-plated brass F-connector is designed for TRISET cables.
• Connector type: F compression
• Impedance: 75 Ω
• Material: nickel-plated brass
• Mounting method: longitudinal compression
• Wide operating bandwidth
• Very low attenuation throughout the operating band
• Sealed on the device side by a rubber gasket
• Sealed on the cable side
• Dimensionally matched to TRISET-113 cable family
• Impedance: 75 Ω
• Material: nickel-plated brass
• Mounting method: longitudinal compression
• Wide operating bandwidth
• Very low attenuation throughout the operating band
• Sealed on the device side by a rubber gasket
• Sealed on the cable side
• Dimensionally matched to TRISET-113 cable family
Details
The MASTER F 113 F-male connector is made of zinc-plated bronze. The features of the connector have been specially adjusted to the TRISET cables. Special construction and high precision of the MASTER F 113 E80342 connector enable easy installation on the cables. The compression method of installation is very simple and guarantees good and stable connection for a long time. Precise thread eliminates problems with screwing the connectors on sockets, which can happen with other plugs. Double compression rings (on the cable) and the O-ring seal (connection side) fully protect the cable and the connection (the equipment) against water penetration.
The connectors should be compressed with the E80075 compression tool.
A very good tool for preparing cable ends is the insulation stripper ABI 212 E8010.
Key features:
- wide operating bandwidth
- watertight connector to cable connection
- very low attenuation over the entire operating band
- excellent adaptation to the transmission line in the whole operating band
- very simple and quick assembly - way of crimping: longitudinal compression
- properly crimped connector is very difficult to tear off the cable - two compression rings
- connector is a monolithic unit
- it is dimensionally matched to the TRISET-113 cable family
- the construction of this connector is protected by numerous patents
- preparation of the cable for crimping (stripping) should be done with tool E8010
- a 7/16" spanner can be used to screw the connector into the socket
- for crimping, the compression tool E80076 should be used
- when comparing this connector with others, it should be noted that the speed, assembly safety and stability of the connection made correspond to the price of the connector
Specifications
Product type | Plug | ||
connector type | F | ||
Brand | MASTER | ||
Cable mounting | Compression | ||
Cable family | Triset-113 | ||
Technical specifications | |||
Impedance | Ohm | 75 | |
Frequency range | MHz | 5...2400 | |
Shielding class | A | ||
Material | Basic | Brass 360 | |
Material | Finishing | Nickel | |
Gasket | Ethylene propylene rubber | ||
Dimensions | Outer diameter | mm | 10.8 |
Dimensions | Inner diameter | mm | 8.4 |
Inner sleeve diameter | mm | 5.0 |
Videos
Signal measurement in SMATV systems – Part 3 Part 3 out of 3 of the guide on how to measure signals in a SAT system. Here we show you how to set an antenna for receiving the DVB-T2 signal.
A short presentation how to compress F connector on TRISET-113 cable and BNC connector on RG-59 cable.
Practical implementation of a home junction box.