EN
PL
CZ
DE
IE
HU
PT
RO
SK
ES
Practical implementation of a home junction box.
€0.39
| Price | Disc. | Quantity | Validity |
|---|---|---|---|
| €0.39 | 0 % | from 1 piece |
Available
The monolithic F-connector, made of nickel-plated brass, is designed for RG-6 type cables.
• Connector type: F compression
• Impedance: 75 Ω
• Material: nickel-plated brass
• Mounting method: longitudinal compression
• Wide operating bandwidth
• Very low attenuation throughout the operating band
• Sealed on the device side by a rubber gasket
• Sealed on the cable side
• Dimensionally matched to the RG-6 cable family
• Impedance: 75 Ω
• Material: nickel-plated brass
• Mounting method: longitudinal compression
• Wide operating bandwidth
• Very low attenuation throughout the operating band
• Sealed on the device side by a rubber gasket
• Sealed on the cable side
• Dimensionally matched to the RG-6 cable family
Details
The monolithic E80332 F-connector is made of brass plated with nickel and is specially prepared for RG-6 cables. Special construction and high precision of the product enable easy installation on the cables. The compression method of installation is very simple and guarantees good and stable connection for a long time. Precise thread eliminates problems with screwing the connectors on sockets, which can happen with other plugs. Double compression rings (on the cable) and the O-ring seal (connection side) fully protect the cable and the connection (the equipment) against water penetration.
The connectors should be compressed with the E80075 compression tool.
A very good tool for preparing cable ends is the insulation stripper ABI 212 E8010.
Key features:
- wide operating bandwidth
- watertight connector to cable connection
- very low attenuation over the entire operating band
- excellent adaptation to the transmission line in the whole operating band
- very simple and quick assembly - way of crimping: longitudinal compression
- properly crimped connector is very difficult to tear off the cable
- connector is a monolith
- preparation of the cable for crimping (stripping) should be done with tool E8010
- a 7/16" spanner can be used to screw the connector into the socket
- for crimping, the compression tool E80076 should be used
- when comparing this connector with others, it should be noted that the speed, assembly safety and stability of the connection made correspond to the price of the connector
Specifications
| Product type | Plug | ||
| connector type | F | ||
| Brand | MASTER | ||
| Cable mounting | Compression | ||
| Toolless | Yes | ||
| Cable family | TRISET B2CA, RG-6 Dipolnet | ||
| Technical specifications | |||
| Impedance | Ohm | 75 | |
| Frequency range | MHz | 5...2400 | |
| Shielding class | A | ||
| Material | Basic | Brass 360 | |
| Material | Finishing | Nickel | |
| Gasket | Ethylene propylene rubber | ||
| Dimensions | Outer diameter | mm | 10.8 |
| Dimensions | Inner diameter | mm | 8.4 |
| Inner sleeve diameter | mm | 4.83 | |
Videos
Related products
€142.94
![Coaxial Cable (75 ohm, class A++): TRISET B2CA 120 dB 1.05/4.6/6.9 [1 m]](https://www.dipolnet.com/img/thumbnails/e1020_1+.jpg/fd33a05505d1af3532b6403cb0144100.jpg)
