F-connector MASTER F (compressed on RG-6 Tri-Shield, TRISET PLUS)

The monolithic E80345 F-connector is made ​​of brass plated with nickel and is specially prepared for RG-6 Tri-Shield cable. The material used ensures resistance to corrosion. High precision ensures superior quality and professional look. The compression method of installation is very simple and guarantees good and stable connection for a long time. Precise thread eliminates problems with screwing the connectors on sockets, which can happen with other plugs. Double compression rings of the F MASTER E80345 connector (on the cable and the O-ring seal on the connection side) fully protect the cable and the connection (also the equipment) against water penetration.

The F MASTER E80345 compression connector is intended for the following cables:

The connectors should be compressed with the E80075 compression tool.

A very good tool for preparing cable ends is the insulation stripper E8010.

• wide operating bandwidth
• watertight connector to cable connection
• very low attenuation over the entire operating band
• excellent adaptation to the transmission line in the whole operating band
• very simple and quick assembly - way of crimping: longitudinal compression
• properly crimped connector is very difficult to tear off the cable - two compression rings
• connector is a monolithic unit
• dimensionally matched to the RG-6 Cu Tri-Shield cable family
• the construction of this connector is protected by numerous patents
• preparation of the cable for crimping (stripping) should be done with tool E8010
• a 7/16" spanner can be used to screw the connector into the socket
• for crimping, the compression tool E80075 should be used
• when comparing this connector with others, it should be noted that the speed, assembly safety and stability of the connection made correspond to the price of the connector