My Cart is empty



Reception of digital satellite platform throughout the house using only one smart card
Example of practical application allowing to:
  • receive terrestrial TV channels,
  • receive FM radio programs,
  • receive satellite broadcasts from two satellites,
    • receive FTA channels,
    • receive pay TV channels (one of SECA MediaGuard digital platform) - on four sat receivers, with the use of one subscription card,
  • watch the image from a CCTV camera on any TV set.
Two Quatro LNBs (A98257) connect with R70808 multiswitch (via eight coaxial cables TRISET-113 E1015). In the diagram below, the inputs of the multiswitch connected with the second LNB (for a second satellite) are not visible (they are physically placed in the second row, behind the first). Possible application of two-tuner PVR receivers requires to install two TRISET-113 E1015 cables from the multiswitch to the R694140 outlets. This will enable simultaneous viewing of one program and recording of another. The example installation distributes signals for three "single" receivers and one two-tuner receiver.
To receive channels of a SECA MediaGuard digital platform on several TVs (up to 8), the subscribers of, Digital+/Astra (Spain), Canal Digitaal (Holland), CanalSat (France), Meo (Portugal) can use single smart card (and subscription) but as many suitable sat receivers as the number of TVs, each equipped with Wireless Client Card for Clone+ (A9911). The original smart card is not put to any receiver, but to the central unit - Clone+ Wireless Smart Card Splitter (A9910) - which wirelessly transfers subscription rights to the Clone+ client cards.
Note: this solution is not applicable in the case of receivers/decoders paired with smart cards - the subscribers may only use the "multiroom" option offered by the service provider.
The antenna system is additionally used for distribution of the image from a CCTV camera (at gate, entrance etc.). The image from the camera can be watched on any TV set.
The cables used:
  • Triset-113 E1015 - TV/satellite cable for indoor applications,
  • Triset-113 PE E1017 - TV/satellite cable for outdoor applications,
  • CAMSET/YAR M5995 - coaxial cable with power wires between the CCTV camera and RF modulator.
The terrestrial antennas should be chosen according to local reception conditions.
Selection of Terrestrial TV Antennas
Steel Satellite Dish: CORAB COR-900 SAE-J (90cm) Universal QUATRO LNB: Inverto Red Extended 0.3dBSecond LNB Mount U-2LNB(800)-JF-connector MASTER F 113 (compressed on Triset-113)FM Antenna: Dipol 1RUZ PM B (omnidirectional H+V)UHF TV Antenna: DIPOL 44/21-60 Tri DigitCeiling IP Camera: Hikvision DS-2CD2125FWD-IM (2MP, 2.8mm, 0.005 lx, IR up to 30m, WDR, IK10, HDMI, H.265/H.264)1-12/21-69 Antenna Diplexer - ZA 6High Speed HDMI Cable with Ethernet (v1.4, 5m, 28AWG, flat)2-Way TV/FM Splitter: Signal R-2HDMI to DVB-T Encoder/Modulator (Full HD 1080p/60Hz, for CCTV systems) 9/8 Multiswitch: Terra MR-908L (active terrestrial path, class A)Subscriber Terminal Outlet: SIGNAL TV/FM/SAT1/SAT2 (PVR)Subscriber Terminal Outlet: SIGNAL TV/FM/SAT1/SAT2 (PVR)
On every TV set connected to the individual receiver, one can choose and watch any of terrestrial TV or satellite programs from the pay-TV platform, and additionally - the image from the analog CCTV camera.