RF Surge Protector: TRANS-DATA 900-2500MHz

Code: A6815
€18.64
Price Disc. Quantity Validity
€18.64 0 % from 1 piece
Available
In a way, many antennas protect the cooperating transceivers (APs, GSM repeaters) against atmospheric discharges. These antennas are DC short-circuited. However, it is not a sufficient solution in the case of a direct strike. A good solution is mounting the antenna on a mast/tower, the base of which is connected to the lightning conductor and grounding system. Additionally, the mast/tower has to be extended well above the antenna (or the antenna should be mounted well below the top of the mast/tower). In the event of a direct lightning strike, the structure carries the electric charge to the ground.
• Protection of a GSM amplifier/repeater against lightning surges
• Max transmitted power: 200 W
• VSWR <1.1
• Insertion loss: 0.2 dB

Warranty

3-year warranty.

Support

Details

During thunderstorms, electronic devices are very vulnerable to damages. The risk of over-voltage caused by lightning electromagnetic pulse (LEMP) is present even in distant spots, up to 1.5 km from the place where a lightning bolt strikes.
A good solution is mounting the antenna on a mast/tower, the base of which is connected to the lightning conductor and grounding system. Additionally, the mast/tower has to be extended well above the antenna (or the antenna should be mounted well below the top of the mast/tower).
In the event of a direct lightning strike, the mast carries the electric charge to the ground. However, to protect the electronic circuitry against LEMP, one should connect between the antenna and AP or cellular repeater a suitable surge protector. TRANS-DATA 900-2500MHz has been specially designed for this purpose.
The right grounding
The lightning protector must be grounded via the clamp and low-impedance wire. To avoid overvoltages, the protector should be connected to low-resistance grounding (below 4 ohm), by screwing or soldering. As the grounding, it is not allowed to use any lightning conductors/arresters or gas installation pipes!
The device protects only the equipment to which is directly connected.
It should be mounted directly to the antenna connector of the GSM repeater, AP etc.

Specifications

Name TRANS-DATA surge protector 900-2500MHz
Product type WLAN/GSM network security
Specifications
Maximum voltage V 230
Connectors Input N-socket
Output N-plug
input count 1
number of outputs 1