Global Invacom QUAD GTU optical satellite receiver with DVB-T (replacement for Triax TVC 06 QUAD)
Code: A9883
Switched-mode power supply designed to power 12 VDC electrical devices equipped with 2.1/5.5 socket, with current consumption not exceeding 1A. It is suitable for the majority of CCTV cameras.
• Power supply dedicated for CCTV cameras
• 12 VDC output
• Max load: 1 A
• Over-current protection
• Over-voltage protection
• Short-circuit protection
• 12 VDC output
• Max load: 1 A
• Over-current protection
• Over-voltage protection
• Short-circuit protection
The QUATRO converter has been designed for output replication of satellite IF signals and DVB-T/T2 and FM/DAB digital terrestrial TV antennas. It is powered from a multiswitch.
• Receiver works with TOU 232 KIT and LNB TOL32
• Converts optical signal to electrical signal (4x SAT + DVB-T)
• Sensitivity: -15...0 dBm
• Converts optical signal to electrical signal (4x SAT + DVB-T)
• Sensitivity: -15...0 dBm
Switched-mode power supply designed to power 12 VDC electrical devices equipped with 2.1/5.5 socket, with current consumption not exceeding 1A. It is suitable for the majority of CCTV cameras.
• Power supply dedicated for CCTV cameras
• 12 VDC output
• Max load: 1 A
• Over-current protection
• Over-voltage protection
• Short-circuit protection
• 12 VDC output
• Max load: 1 A
• Over-current protection
• Over-voltage protection
• Short-circuit protection
The TOS 02D optical splitter splits optical signal from optical output LNB A9885 or the optical transmitter of the A9880 set into two optical paths. The splitter can be also used in any PON networks.
• Splits optical line into two paths
• Easy installation in standard cabinets / installation boxes
• FC/PC sockets
• When needed - can be replaced by a 3-out or 4-out splitter
• Easy installation in standard cabinets / installation boxes
• FC/PC sockets
• When needed - can be replaced by a 3-out or 4-out splitter
Opto-Spt3 BOX optical splitter splits optical signal from optical output LNB A9885 or the optical transmitter of the A9880 set into three optical paths. The splitter can be also used in any PON networks.
The TOS 04F optical splitter splits optical signal into four optical paths.
This COMSAT patch cord is a section of an outdoor single-mode fiber optic cable with a length of 10 meters, terminated on both ends with FC/PC connectors.
The optical SAT/RTV OTX 1310 KIT from TRIAX allows the introduction of DVB-S/S2 satellite signals and DVB-T2 digital terrestrial TV, DAB radio and FM radio into a fibre optic installation.
• Fiber optic cabling
• One fiber optic cable instead of 5 or 9 cable bus
• Wideband LNB dedicated for satellite installation
• One fiber optic cable instead of 5 or 9 cable bus
• Wideband LNB dedicated for satellite installation