English
Polski
Česky
Deutsch
Irish
Magyar
Português
Română
Slovenský
€7.51
| Price | Disc. | Quantity | Validity |
|---|---|---|---|
| €7.51 | 0 % | from 1 piece |
Available
Steel mast 38 mm/1 m galvanized with the possibility of joining /system C/. The galvanizing process ensures durability and resistance to corrosion while maintaining an aesthetic appearance.
• Steel mast
• Length 1 m
• Diameter 38 mm
• Wall thickness 1.5 mm
• Interlocking
• Galvanic zinc plating
• Length 1 m
• Diameter 38 mm
• Wall thickness 1.5 mm
• Interlocking
• Galvanic zinc plating
Details
The 1 meter long hot-dip galvanized steel antenna mast is made of 38 mm diameter pipe with a wall thickness of 1.5 mm. The galvanizing process ensures durability and resistance to corrosion while maintaining an aesthetic appearance. A plastic plug is installed on the underside of the mast.
The galvanizing process ensures that all surfaces and edges are evenly covered with a protective coating. In addition, after the galvanizing process itself, the coating undergoes a sealing and passivization process. The whole provides very good protection against the effects of atmospheric agents.
Mast weight: 1.4 kg
Connecting masts into a single permanent whole
Special embossments at the tip make it possible to connect elements.
The mast has been designed in such a way that it can be combined into a larger whole. Thanks to special embossing at the ends of the mast, it is possible to join the elements using a 9 cm long groove system by knocking in another segment in such a way that the embossing overlaps. Once joined, it is not possible to disconnect the segments.
Being able to join masts together is particularly important because:
- it enables cheap and easy shipment (delivering a long mast is often very expensive or impossible),
- shorter elements are much easier to transport by car and take up to the roof,
- it makes it possible to adjust mast height to specific needs.
The maximum height of the composite mast depends on:
- the selected safety coefficient,
- the weight and surface area (wind resistance) of suspended elements,
- the antenna arrangement (larger antennas should be placed at the bottom),
- the type and rigidity of the wall/chimney clamp,
- the type and number of additional anchoring clamps.
Example of a joint between two poles 1.5 m and 1 m in length.
The following masts can be combined in any configuration:
Specifications
| Product type | Mast | ||
| Material | Steel | ||
| braid coverage | Galvanized | ||
| Mast joining system | C | ||
| Length | m | 1.0 | |
| Diameter | mm | 38 | |
| Wall thickness | mm | 1.5 | |
| Weight | kg | 1.4 | |
